Car-PC Forum | Car computer support

Home / Power / Problems with booting CarPC [Viewed 5560 Times]

Back

Problems with booting CarPC
By: kfalken Rank: Starfleet Ensign Postings: 1 From: n/a	Posted: Mo Sep 11, 2006 - 11:01 Hello, I have bought a CarPC and connected it to + and - on the batteri, i have also connected it to the Ignition where the radio used to be. This is also working but it takes about 30-40sek before the pc starts to boot. I have changed the bios to PASS in the CarPC Option. The screen a Xenarc 700TSV i bought also is connection to + and - on the batteri. But every time the pc boots it wants to calibrate the screen ? Further more i have som noise in my speakers when i accelerate this was not there before ?
By: Saraneus Rank: Starfleet Ensign Postings: 3 From: n/a	Posted: Mo Okt 09, 2006 - 02:06 Hello, My car pc stays silent for about 10 secs until it starts to boot. Why doesn't it boot immediately having set the delay time "pass"?
By: darph Rank: Starfleet Lieutenant Postings: 19 From: Germany	Posted: Do Nov 09, 2006 - 12:12 I think you have to change your Jumper J6 look in the manual how it have to set to change the start. Fahre nicht schneller wie dein Schutzengel fliegen kann, meiner ist aus Erfahrung sehr schnell
By: admin Rank: Starfleet Vice Admiral Postings: 463 From: Germany	Posted: Do Nov 09, 2006 - 02:48 >My car pc stays silent for about 10 secs until it starts to boot. Why doesn't it boot >immediately having set the delay time "pass"? "Pass" is the shortest possible option. 10 sec delay is normal. >The screen a Xenarc 700TSV i bought also is connection to + and - on the batteri. But >every time the pc boots it wants to calibrate the screen ? Please re-install Touchkit software and do not enable the option "Re-calibrate on every boot".